Control voltage: 100/110/120 VAC.
Reset: Automatic.
Model: Inverse type.
Solid-state Relay Provides Three Operating.
Functions in a Compact Package.
Prevents burnouts in 3-phase induction motors due to overcurrent,
open-phase, or reverse-phase.
LEDs indicate operation of the selected operating function S8JX-P15012CD EtherNet/IP Connection Guide.
Wide setting ranges: current: 1 to 160 A; operating time: 1 to 40 s S8JX-P15012CD
Protects the motor from reversing without starting it.
before using the K2CM. Independent type, the function of the built-in controller is not RS-232C, the maximum 256 points.Input voltage: 400 ~ 500 VAC3 phase.
Rated power: 240W.
Output voltage: 24V.
Output current: 10A.
DIN guide rail installation, with 5 A ~ 40 A output current of the power supply S8JX-P15012CD EtherNet/IP Connection Guide.
3 phase 400 ~ 500 VAC.
5, 10, 20 and 40 A; 24 VDC output.
High stability, low ripple and low noise level.
Compact design.
Add fuse protection.
Natural draft。
In addition to the CE tag, but also in compliance with UL60950 (CSA22.2-60950), UL508.
Conform to EN61000-3-2.
Parallel / series operation. Input/Output: Outputs.
Internal I/O circuit common: NPN (– common) S8JX-P15012CD EtherNet/IP Connection Guide.
I/O points: 8 points.
I/O connection method: Sensor connector.
Rated voltage for I/O power supply: 24 VDC.
Eight Waterproof Terminal Models.
Emphasizing Cost Efficiency.
Reduced Labor.
Connection using connectors reduces the lead time,
required for installation. No tools are required for,
connection to a variety of devices.
Reduced Wiring.
Signal line wiring has been reduced so that the,
Terminal can be mounted closer to sensors and,
other devices.
Relay Box not Required.
Environment-resistant, dust-tight, drip-proof,
connstruction (IP67) enables direct on-site,
mounting S8JX-P15012CD Manual.
Easier Maintenance.
Significant reductions not only in setup time but also,
maintenance time.
Reduced Space, Improved Operability,
Compact design (160 x 54 mm (W x H)) (88-point models) S8JX-P15012CD Manual.
Settings and connections can be performed using,
the switch and connectors on the front side of the Terminal.
System Configuration.