Digital Rotary Pulse Meter Capable of 50 kHz Measurements.
Visual confirmation of judgement results through display colors that switch,
between red and green.
Measures High-speed Pulses at 50 kHz.
Provides high-speed pulse measurements up to 50 kHz of rotary encoder,
or ON/OFF pulse.
signals and can perform rotating measurement of high-speed rotating objects K2CM-2L Communications Manual.
Note: No-voltage contacts of up to 30 Hz are supported K2CM-2L
Six Measurement Operations Including Rotation (rpm)/Circumferential,
Speed, Ratio, and Cumulative.
One Rotary Pulse Meter has 6 rotary pulse measurement functions to,
support a variety.
of pulse measurement applications. Select the best function for your,
application from the K2CM-2L Communications Manual.
following: Rotation (rpm)/circumferential speed/instantaneous flowrate,
(value proportional to frequency), absolute ratio, error ratio, error,
flow rate ratio, and passing.
speed (value inversely proportional to frequency).
DeviceNet models added to the series. Input type: DC voltage input type.
Output type: communication; RS-485; NPN open collector (HH, H, PASS, L, LL).
Event input terminal 5 points (TIMING, S-TIM, HOLD, RESET, ZERO) is equipped with K2CM-2L Communications Manual.
External supply 80mA DC12V.
Power supply voltage: AC/DC24V.
96 (W) * 48 (H * 95mm) depth
Some models are not equipped with.
The most suitable voltage and current signal simulation, measurement and display, identification of the panel table.
Action determine the color, can switch the green / Red 2 kinds of color display.
Equipped with the sub pressure gauge for monitoring the operation trend.
External event input can be applied to a variety of measurement and identification situations.
DeviceNTime specification: Instantaneous type.
Current setting range: 20 to 65 A.
Operating voltage: 200/220/240 VAC.
Resetting method: Automatic.
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase).
Protects 3-phase induction motors and their loads from damage.
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase.
Circuit and output relay operation can be checked by just operat,
ing the test button.
The set time value can be checked easily because operation time,
is indicated from the start of operation K2CM-2L Manual.
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions will,
depend on the load wiring length, inverter carrier frequeency, basic,
frequency, and load conditions K2CM-2L Manual. Error will occur in the operating,
values of the overload elements. It is recommended to test operation,