Small, highly sensitive 1 pole signal relay.
Small size 12.5 (L) * 7.5 (W) * 10 (H) mm.
Wide range of contact switch area 1mA ~ 1A.
High sensitivity coil 150mW.
Plastic sealed type, excellent environmental performance.
Coil contact between the Part68 FCC standard. (1500V, 10 * 160 s)Terminal (Wire connection): Push-In Plus Terminal GT1-ID32ML PROGRAMMING MANUAL.
Classification: Standard.
Latching lever (Test switch): No GT1-ID32ML
Rated input voltage: AC, 230V.
Global standard size, low profile slim.
I/O relay with width 6.2 mm.
Realized about 25% lower profile than conventional.
products, contributing to further miniaturization of the control panel.
Realized opening and closing ability with one pole 6 A slim shape.
Micro load products for one pole 50 mA using Au-plated GT1-ID32ML PROGRAMMING MANUAL.
contacts for small load switching also available.
Since G2RV is a transparent case, confirming the state of,
the contact with the naked eye is possible, and easy to,
confirm abnormality on-site (installed location).
Screw terminal is also stocked to meet the screw type needs.
Mounted relay uses plug-in terminals that are difficult to,
bend when exchanging GT1-ID32ML PROGRAMMING MANUAL. Insulation method: Phototriac coupler.
Zero cross function: Yes.
Indicators: Yes(See page 5).
Rated output load: 20 A, 100 to 240 VAC (resistive load: AC, Class1).
Refer to Safety Precautions for All Solid State Relays.
Detects failures in SSR used for heater,
temperature control and simultaneously,
outputs alarm signal. This SSR supports the,
safe design of heater control systems, and,
contributes to maintenance improvements by the user.
Main detection items:
SSR short-circuits and SSR open-circuits,
Alarm output possible to NPN/PNP-input devices.
The failure-detection function is built-in and power is supplied,
from the main circuit power supply making wiring simple.
Slim design (width: 22.5 mm) incorporating a heat sink.
In addition to screw mounting, DIN track mounting is also possible.
Certified by EC, UL, and CSA. Unit: Terminal block model.
I/O classification: Digital input.
Internal I/O common: PNP (- common).
I/O points: 16.
I/O connectionss: M3 terminal board GT1-ID32ML Manual.
Power supplyvoltage: 24 VDC.
I/O specification: DC/transistor.
Digital I/O Units Compatible with MULTIPLE I/O TERMINAL,
Terminal block, connector, and high-density connector,
models are available.
The ciircuit block of the terminal block model can be,
mounted or dismounted for ease of maintenance without,
disconnecting the wires GT1-ID32ML Manual.
DIN track mounting.