Sensing method: Retro-reflective.
Appearance: Vertical.
Connection method: Pre-wired.
Sensing distance: 3m.
Water- and Oil-resistant.
Photoelectric Sensor with.
Metal Housing Used for Long.
range Sensing.
Excellent resistance against the water and oil.
Easy application in locations with oil mist E5CN-HC2M-500 User's Manual.
Long-range sensing up to 30 m with Through-beam models.
Shock resistance rated at 1,000m/s2 E5CN-HC2M-500
Product lineup includes metal M12 pre-wired connector models.
NPN/PNP selector switch output. Protection tube diameter: screw pitch M8.
Wire length: 4m.
Core line type: K (CA).
Temperature sensing part of temperature controller.
In the application field of packaging molding machine is widely used,
Further strengthened the high cost models E5CN-HC2M-500 User's Manual.
Easy to install / replace the structure.
With springs, you can use the active part (E52Z-CA1D-40). Ontology: program type.
Size: 48 x 96mm.
Type: control valve control type (1 input).
Control mode: 1 channel position ratio control.
Output (control / transfer) points: relay output (open 1 + 1 point).
Output (SUB) points: 2 points.
Event entry point: 4 E5CN-HC2M-500 User's Manual.
Serial communication: -.
New high speed, high precision digital regulator (Cheng Xuxing)!
Can be set up to 32 kinds of procedures.
1 units can be coordinated to run up to 4 channels.
High speed acquisition of 50ms.
With CX-Thermo on the computer easily set. Optional laser sensor to provide the best laser sensor for different scenes at the most suitable price.
Make the workpiece color, material, surface state is different, can also be a compact body to achieve stability detection.
[stability] [rest assured].
OMRON original HSDR-CMOS (Seed and Dynamic Range High).
Dynamic range 500 thousand tiimes E5CN-HC2M-500 Manual.
Adjusting the CMOS shutter time according to the workpiece.
Can adjust the power of light, to achieve the best of the diffusion of light intake.
The background is used as a benchmark to detect all parts of the benchmark.
CCan not be affected by the workpiece surface state and the stability of the impact of the tilt, even if the workpiece changes, there is no need to set E5CN-HC2M-500 Manual.