E32-DC200B4R type: standard type; soft (new standard),
Specialty: M6 screw with casing,
Bending radius (mm): R; R1.
Standard test object (minimum test object) (mm) 1: (0.005),
Fiber element for meeting diversified needsFree change detection direction.
Detection direction can be according to the front, side (up and down, around 90 units) change E5CN-FRMT-500 USER'S MANUAL.
Can be similar to the feeling of a limit switch installation E5CN-FRMT-500
Type: AC type.
Shape: shield.
Detection range: 15mm.
Action mode: NO/NC (toggle). Appearance: Unshielded.
Sensing surface: Top.
Sensing distance: 2.5 mm.
Output configuration: NPN.
Model: Operation mode, NC.
Advanced Performance and Wide.
Range of Selections in a Super.
compact Size E5CN-FRMT-500 USER'S MANUAL.
Only 5.5 × 5.5 mm with a built-in Amplifier.
Maximum sensing distance: 2.5 mm. Stable detection even with,
workpiece fluctuations.
Response frequency: 1 kHz.
Low current consumption. Size: 48 * 48mm, terminal type.
Category: control output 2 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output 1: voltage output (SSR driver).
Control output 2: voltage output (SSR driver) E5CN-FRMT-500 USER'S MANUAL.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event input points: -.
Transfer output: -.
Communication: RS-485.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of tthe thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV E5CN-FRMT-500 Manual.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can performm flexible contact output E5CN-FRMT-500 Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.