Size: 1/16 DIN 48 × 48 × 78 (W × H × D).
Power supply voltage: 24 VAC/VDC.
Input type: Thermocouple or Resistance thermometer.
Alarm output: 2.
option units Mounting: Yes.
Control output: Current output.
Previous mode: E5CZ-C2MD.
This Best-selling General-purpose,
48×48-mm Temperature Controller,
Is Now Even Better E5AC-QQ2DSM-009 lnstruction Manual.
Controllers now available with analog inputs E5AC-QQ2DSM-009
Faster sampling at 250 ms.
Transfer output provided for easy output to recorders.
Models available with a loop break alarm (LBA) and,
heater short alarm (HS alarm).
Easy setting with 11-segment displays.
Setting protection indicator informs operator when,
protection is enabled.
Manual output provided.
New protocol called Modbus is installed in the models,
with communications E5AC-QQ2DSM-009 lnstruction Manual.
USB-Serial conversion cable is available.
Note: Refer to Precautions on page 33. E32-T11F type: resistant to environmental type; resistant to drugs,
Specialty: Teflon coated spherical probe,
Shape / detection distance (mm): 2500; 2000; 1300; (520),
Bending radius (mm): R4.
Standard test object (minimum test object) (mm) 1: 4 (0.1),
Fiber element for meeting diversified needsPressure range: Negative pressure; 0 to -101 kPa E5AC-QQ2DSM-009 lnstruction Manual.
ON/OFF output: Open collector (two independent outputs).
Linear output: 1 to 5 V.
Model: NPN output.
Pressure Sensor with.
Easy-to-Read LED Display.
Pressure status can be checked at a glance from the,
digital display and bar display.
Measurement pressure prevents incorrect outputs due,
to momentary pressure changes.
Perform automatic teaching simply by teaching pressure,
values for good and bad products.
Industry’s smallest models at just 28 × 28 × 29 mm.
Only in hysteresis mode. Size: 48 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: RS-232C.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makees the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E5AC-QQ2DSM-009 Manual.
Through the infrared port can be carried out from the frront of the communication E5AC-QQ2DSM-009 Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.