I/O Cable (for I/O to Interface Racks) 50 m (L) CV500-CN532Model: C200HW-BC101-V1.
No. of I/O slots: 10 slots.Unit type: CJ1 Basic I/O Units.
Product name: Transistor Output Units.
Specifications: Output type, Sinking;
I/O points, 64 outputs;
Maximum switching capacity, 24VDC, 0.3A;
Commons, 16 points, 1 common;
External connection, Fujitsu connector CP1L-L14DT-A OPERATION MANUAL.
No. of words allocated: 4 words CP1L-L14DT-A
Current consumption: 5V, 0.17A; 24V, --.
Standards: UC1, N, L, CE.
A Wide Range of Basic Output,
Units for High Speed Output,
and Different Applications.
These Output Units receive the ,
results of output instructions ,
from the CPU Unit and perform ON/OFF,
control for external devices.
High-speed Output models CJ1W-OD213 and,
CJ1W-OD234 can help to increase system CP1L-L14DT-A OPERATION MANUAL.
throughput. C500-RT SYSMAC BUS Remote I/O Master Slave Wired C500-RT201.
Master station unit remote I/O.Product name: N@@-type CPU Units with 30 I/O Points.
Specifications: Power Supply, 100 to 240 VAC; Inputs, 8; Outputs, 6;
Output type: Transistor (sinking).
Program capacity: 8K steps.
memory Data capacity: 8K words CP1L-L14DT-A OPERATION MANUAL.
External powersupply(24 VDC): --.
Current consumption: 5 V, 0.22A; 24 V，0.02A.
Standards: UC1, N, L, CE.
The CP1E Programmable Controller: Economical, Easy to use, and Efficient.
The E@@(S)-type Basic CPU Units provide cost,
performance and easy application with only basic functionality.
The N@@(S@) and NA-types Application CPU Units,
support Programmable Terminal connection, position control,
and inverter connection. Unit type: CJ1 CPU Bus Units.
Product Name: Position Control,
Unit with MECHATROLINK-II interface.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications.
Direct operation by ladder programming.
Control mode: Position control,
speed control or torque control;
No. of axes: 2 axes.
No. of unit numberrs allocated: 1 CP1L-L14DT-A Manual.
Current consumption : 5V, 0.36A; 24V,--.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
and Batch Management.
Control Servos for up to 16 axes in,
a motion network with one Position,
Control Unit that supports MECHATROLINK-II CP1L-L14DT-A Manual.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.