Terminal (Wire connection): Push-In Plus Terminal.
Classification: Standard.
Latching lever (Test switch): No.
Rated input voltage: DC, 12V.
Global standard size, low profile slim.
I/O relay with width 6.2 mm.
Realized about 25% lower profile than conventional.
products, contributing to further miniaturization of the control panel G9H-205S DC12 PDF datasheet.
Realized opening and closing ability with one pole 6 A slim shape G9H-205S DC12
Micro load products for one pole 50 mA using Au-plated.
contacts for small load switching also available.
Since G2RV is a transparent case, confirming the state of,
the contact with the naked eye is possible, and easy to,
confirm abnormality on-site (installed location).
Screw terminal is also stocked to meet the screw type needs G9H-205S DC12 PDF datasheet.
Mounted relay uses plug-in terminals that are difficult to,
bend when exchanging. Category: relay output.
Points: 8 points (1a * 8).
Common line processing on the connector side: corresponding (+ public).
Rated voltage: DC24V.
To achieve the control cabinet of miniaturization / save time,
Relay terminal for 8 point output.
Small size of 136 * high 80 * 55mm G9H-205S DC12 PDF datasheet. (vertical installation)
The total wiring of the connector cable is realized.
The common end can be easily connected with the independent contact and the short circuit piece.
The G70D-SOC08 and G70R-SOC08 are connected by a short circuit chip.
When the relay does not need the tool, the relay is convenient to replace the work.
With terminal cover to prevent electric shock.
Diode for internal coil surge absorption.
DIN guide rail installation, screw mounting common. Action indicator: there are.
Applicable load of output: DC5 3A ~ 110V.
Input rated voltage: DC5 ~ 24V.
IInsulation: photo coupler G9H-205S DC12 PDF catalog.
Zero trigger function: No.
Socket terminal type with same shape as MK type power relay.
New international standard certification (-VD type).
Achieved UL, CSA, EN (VDE certification) standard ccertification G9H-205S DC12 PDF catalog. (type -VD)
Socket terminal type of same size with MK (2 pole type).
A model with an action indicator to check the status of the input.