Appearance: Shielded, M12.
Sensing distance: 3 mm.
Output configuration: DC 3-wire (NPN).
Operation mode: NC.
Proximity Sensor Ideal for the Food and Beverage Industry. Sensing method: Reflective type.
Sensing distance: 0 to 3 mm.
Output configuration: Turns ON when wafer carrier is present.
Cable length: 2 m E2F-X1R5Y1 2M PDF datasheet.
Photomicrosensors for detecting,
wafer-carrier mounting E2F-X1R5Y1 2M
The mounting position is set with a pedestal.
The contact surface with the wafer carrier uses a special chemical,
resistant fluororesin.
The unique optical system enables stable detection of almost all,
wafer-carriers.
Light modulation effectively reduces external light interference.
Utilizes talc-free clean cables E2F-X1R5Y1 2M PDF datasheet. Size: M8, Shielded.
Sensing distance: 2.0 mm.
Connection: Pre-wired.
Body material: Stainless steel.
Thread length (overall length): 27 (40).
Output configuration: NPN.
Operation mode NC.
Safe Mounting with Greater.
Sensing Distance.
Ensures a sensing distance approximately 1.5 to 2,
times larger than that of any conventional OMRON Sensor.
Problems such as the collision of workpieces are eliminated E2F-X1R5Y1 2M PDF datasheet.
Full range of standard sizes (M8, M12, M18 and,
M30; both long and short barrels).
Modular construction simplifies customization. Size: 96 x 96mm.
Type: power AC/DC24V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 4.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makes tthe process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output E2F-X1R5Y1 2M PDF catalog.
Through the infrared port can be carried out from the frront of the communication E2F-X1R5Y1 2M PDF catalog.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.