High performance price ratio standard type proximity sensor.
Standard cable protector.
The new DC two-wire type.
Non polar proximity sensor.
Type: DC / wire type.
Polarity: there.
Shape: shield, M8.
Detection range: 2mm.
Action mode: NO. Size: 48 x 96mm.
Type: power AC/DC24V with.
Shell color: silver E5GN-Q1P User's Manual.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling E5GN-Q1P
Auxiliary output points: 2 points.
The detection function of the broken wire and SSR fault of heater: detection function of single phase or three phase heater.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: RS-422.
General thermostat new high performance (high resolution, high speed, high precision input) type products E5GN-Q1P User's Manual.
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors E5GN-Q1P User's Manual.
Also supports remote SP.
Add PV/SV status display function, convenient to check the state of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV.
By supporting software (Ver.4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output.
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault.
Position ratio type. E32-L16 type: special beam type; liquid level detection,
Specialty: the detection rangge of the detection location is scattered less than 0 E5GN-Q1P MANUAL. 2mm,
Bending radius (mm): R25.
Fiber element for meeting diversified needsE32-T25X type: standard type; standard,
Specialty: flat shape (small),
Shape / detection distance (mm): 2270; 220; 125 (50),
Bending radius (mm): R10 E5GN-Q1P MANUAL.
Standard test object (minimum test object) (mm) 1: 1 (0.0005),
Fiber element for meeting diversified needs