Appearance: Shielded, M18.
Sensing distance: 4 mm.
Output configuration: DC 2-wire.
Model: Operation mode, NC.
Chip-immune Inductive.
Proximity Sensor.
Correct operation even with aluminum or iron chips sticking,
to the Sensor.
Only the sensing object is detected.
Pre-wired Smartclick Connector Models also available E5EN-HPRR2BFMD-500 User's Manual. Appearance: Shielded, M12.
Sensing distance: 4 mm E5EN-HPRR2BFMD-500
Output: PNP.
Model: Operation mode NC.
Aluminum and Iron Both.
Detectable from Long Distances. Size: 48 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: built-in SSR output.
Control output 2: built-in SSR output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points E5EN-HPRR2BFMD-500 User's Manual.
The detection function of the broken wire and SSR fault of heater: detection function of single phase or three phase heater.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: RS-422.
General thermostat new high performance (high resolution, high speed, high precision input) type products.
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved E5EN-HPRR2BFMD-500 User's Manual.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV status display function, convenient to check the state of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV.
By supporting software (Ver.4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output.
Increease the control output ON/OFF number counting function, can predict the temperature controller internal relay fault E5EN-HPRR2BFMD-500 MANUAL.
Position ratio type. E32-A02 type: special beam type; liquid level detection,
Specialty: when there is liiquid into the light, not susceptible to the effects of bubbles and water droplets,
Bending radius (mm): R4 E5EN-HPRR2BFMD-500 MANUAL.
Fiber element for meeting diversified needs