Appearance: Standard.
Sensing method: Through-beam type (with slot).
Cable length: 2 m.
Sensing distance: 5 mm (slot width).
configuration Output: Light-ON.
Indicator mode: No incident light.
Model: NPN output.
Slim, Compact Photomicrosensor.
that is still easy to use.
Compact, thin profile enables dense mounting E5CS-QKJU-W INSTRUCTION Manual.
Indicator is visible from both sides.
Wide operating voltage range: 5 to 24 VDC E5CS-QKJU-W Case color: Black.
Control output: Current output.
Control mode *1: Standard or heating/cooling.
No. of auxiliary outputs: 1.
Detection of heater burnout, SSR failure, and heater overcurrent: --.
No. of event inputs: --.
Transfer output *2: Transfer output using control output.
Communi cations: RS-485 E5CS-QKJU-W INSTRUCTION Manual.
Previous model: Thermocouple input, --;
Resistance thermometer input, --.
New 48 x 24-mm Basic Temperature,
Controller with Enhanced Functions and,
Performance. Improved Indication Accuracy,
and Preventive Maintenance Function.
Indication Accuracy.
Thermocouple input: ±0.3% of PV (previous models: ±0.5%),
Pt input: ±0.2% of PV (previous models: ±0.5%),
Analog input: ±0 E5CS-QKJU-W INSTRUCTION Manual. 2% FS (previous models: ±0.5%),
Models are available with screw terminal blocks or screwless,
clamp terminal blocks.
A PV/SV-status display function can be set to automatically alternate,
between displaying the status of the Temperature Controller (auto/
manual, RUN/STOP, and alarms) and the PV or SV.
Preventive maintenance for relays in the Temperature,
Controller using a Control Output ON/OFF Counter.
Switch the PV display between three colors.
Compatible with Support Software (CX-Thermo version 4.2 or higher).
Eleven-segment displays.
Models are available with one or two alarm outputs E5CS-QKJU-W Manual. Appearance: Shielded, M12.
Sensing distance: 2 mm.
Output configuration: DC 2-Wire Models.
Model: Operation mode, NO.
Chip-immune Inductive.
Proximity Sensor.
Correct operation eeven with aluminum or iron chips sticking,
to the Sensor E5CS-QKJU-W Manual.
Only the sensing object is detected.
Pre-wired Smartclick Connector Models also available.