High performance price ratio standard type proximity sensor.
Standard cable protector.
The new DC two-wire type.
Non polar proximity sensor.
Type: DC three wire / wire type.
Shape: non shield, M12.
Detection range: 5mm.
Output configuration: PNP.
Action mode: NO. Name: Temperature Controller (See note 1 E5CS-QKJ INSTRUCTION Manual. ).
Power supply: 24 VDC.
No. of control points: 2.
Control output: Transistor output E5CS-QKJ
Auxiliary output: Transistor output: 2 pts (sourcing).
Functions: Heater burnout alarm (See note 3.), Heating or heat/cool,
control is selectable (See note 4.)Event input: 1 point per Unit.
Communications functions: RS-485.
Input type (See note 5.): Platinum resistance thermometer.
New DIN Track Mounting Temperature E5CS-QKJ INSTRUCTION Manual.
Controller.
Two channels of temperature control available despite width of,
only 22.5 mm.
The Temperature Controller itself can be replaced without,
changing terminal wiring.
Use in combination with a compact Setting Display Unit to,
reduce communications programming requirements.
Front-panel LED indicators for easy operation monitoring.
Power supply and communications wiring not required between,
Units when mounted side-by-side E5CS-QKJ INSTRUCTION Manual.
CompoWay/F communications protocol supported.
UL, CSA, and CE Marking compliance. Size: M30 (brass), single distance, shielding type.
Detection range: 10mm.
Connection mode: lead type (cable length is 2M and 5m two).
Thread length: Standard type.
Output type: PNP.
Action mode NC.
Set up the new standard of the world economy proximity sensor.
OMRON as a pioneer and leader in proximity sensor industry,
Now bring you a new E2B proximity sensor with high performance to price rratio E5CS-QKJ Manual.
This series of products are complete,
Aimed at reasonable prices to meet customer demand for high quality and high reliability of the sensor.
We have tested the product not only on the protection level (IP67) specific item,
Thhe oil spray test was carried out on the condition of the work site E5CS-QKJ Manual.
Simulation test was carried out in the environment of high oil mist concentration.