Type: controller with terminal blocks.
Size: 1/8DIN, 48 * 96 * 78mm.
Power supply voltage: AC100 ~ 240V.
Type of input: thermocouple or platinum resistance.
Alarm output: 3.
Control output: current output.
Heater disconnection: yes.
Install optional unit: have.
Best selling multi purpose thermostat is now more outstanding E2EZ-X8D1-M1GJ INSTRUCTION sheet.
Temperature controller is now available for analog input E2EZ-X8D1-M1GJ
A more rapid sampling rate 250ms.
Provide transfer output, can be simple output to the recorder.
The model is optional with the circuit breaking alarm (LBA) and the heater short circuit alarm (HS).
Simply set the 11 segment display.
Equipped with a manual output function.
New type of installation with communication Modbus E2EZ-X8D1-M1GJ INSTRUCTION sheet.
USB serial conversion cable optional. Size: 48 x 48mm.
Body: terminal type.
Type: control output 1 point type (power AC/DC24V).
Shell color: black.
Control output: linear voltage output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
The failure detection function of the heater with the broken line and SSR: -.
Event entry point: 2.
Transfer output: output (using control output) E2EZ-X8D1-M1GJ INSTRUCTION sheet.
Communication: -.
General thermostat new high performance (high resolution, high speed, high precision input) type products.
Support simple operation, preventive maintenance, using a new type of liquid crystal, visual angle, contrast to enhance.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
All models (thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the thermostat.
(automatic / manual, RUN/STOP, alarm), interactive display PV/SV.
By supporting software (CX-ThermoVer.4.0) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay faultSize: 48 * 48mm, terminal type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase heater detection function.
Event entry point: 2.
Transfer output: -.
Communication: RS-485.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of thhe thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV E2EZ-X8D1-M1GJ Manual.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can performm flexible contact output E2EZ-X8D1-M1GJ Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.