Type: medium and low temperature.
Measuring temperature range: - 50 ~ +500 C.
The target size: 40mm diameter (from 500mm).
No need to contact the workpiece, you can measure the temperature.
Achieve no damage, health and efficient temperature management.
A small spot diameter 3mm and 8mm diameter two types E2C-GF4B INSTRUCTION sheet.
Reproduction of positive and negative 0.5 degrees Celsius, response speed of 0 E2C-GF4B4 seconds,
(95%) with high precision and high speed measurement.
In addition to the original middle temperature (0 ~ +500 C),
Also added in low temperature (- 50 DEG C ~ +500),
High temperature (0 ~ +1000 degrees C) models.
New measurement distance up to 500mm, 1000mm long distance type.
Use another programmer, can change the temperature monitoring, radiation rate,
Moving average function and output range E2C-GF4B INSTRUCTION sheet.
(picture for the installation of programmer in the ES1 body)E3X-DA6TW-S amplifier unit
NPN outputSize: 48 x 96mm.
Ontology: terminal type, temperature input type.
Type: control output 1 point type (power AC/DC24V).
Shell color: black.
Control output: relay output.
Control mode: standard or heating cooling E2C-GF4B INSTRUCTION sheet.
Auxiliary output points: 3 points.
Heater with broken wire, SSR fault, heater over current detection function /ES1B power supply: single phase heater with detection function.
Event entry point: 2.
Transfer output: -.
Communication: -.
The general temperature controller 96mm, 48 * 96mm square has been upgraded to improve the performance and function of /.
Indicates that the accuracy of the upgrade, increase the function of prevention and maintenance, further enhance the performance.
Add PV/SV state display function, to see the state of the thermostat
(automaticc / manual, RUN/STOP, alarm), interactive display PV/SV E2C-GF4B Manual.
Increase the number of control output ON/OFF counting function, can prevent the maintenance of temperature controller internal relay.
Increased the 3 segment display, which cann display the current value / target / operation E2C-GF4B Manual.
Increased the PF key, the distribution of automatic / manual, RUN/STOP, etc., can be a key operation.