Model : CVM1-MP201-V2.
Position Control Unit (NC222) for.CV500-ET CPU Bus Unit for Com Ethernet Unit CV Series Only CV500-ETN01.
10BASE-5 type.Name: MIL Connectors.
Specifications: Outputs; 32 outputs ; NPN; --.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet CRT1-ID16S UL Standards and CSA Standards.
Wiring material cost can be reduced CRT1-ID16S
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error CRT1-ID16S UL Standards and CSA Standards. CV500-RM SYSMAC BUS Remote I/O Master Unit Wired CV500-RM221.
Wire Type.Model : CV500-CN127.
BASIC unit for connecting the printer (1.5m)(Centronics).Unit type: CS1 Special I/O Units.
Product name: Isolated-type,
Resistance Thermocouple Input Units.
points Input: 4 inputs.
Signal range selection:
Set separately for each input.
I/O type: Pt100, JPt100 CRT1-ID16S UL Standards and CSA Standards.
Conversion speed (resolution):
250 ms/4 inputs.
Externa connection: Removable erminal block.
No. of unit numbers allocated: 1.
Current consumption: 5V, 0.25A; 26V, --.
Standards: UC1, CE.
Provides the functionality of isolators,
power supplies, signal converters,
and other devices.
The Analog Input Unit converts analog,
input signals such as 1 to 5 V or 4 to 20mA,
into digital values, and takes the values,
scaled in industrial units, and transfers,
it to the CPU Unit as the process value.
Because of this, no ladder program is required,
at the CPU Unit for scaling.
The Analog Output Unit converts analog output set,
values from the CPU Unit to analog output signals,
such as 4 to 20 mA or 1 to 5 V, and outputs them.
The built-in functions, such as measurement value,
alarms, rate-of-change calculations, and square roots,
have enabled major savings in cost and sppace compared,
with previous systems CRT1-ID16S Manual.
High-resolution Models and 8-point Input Models are,
also available.
By combining the Units, logging/monitoring.
systems can be constructed,
or the Units can be used together with LCBs/LCCUs,
to construct complete process control systems CRT1-ID16S Manual.
Parameters can be easily displayed and set in an,
easy-to-understand form without special tools.